Roof Batten Calculator
Estimate batten rows and running length for rectangular roof planes. Enter the distance between your first and last batten, a maximum gauge and your supplier’s stock length.
How to calculate roof battens
Measure between the first and last rows
Establish the end batten positions from your roof covering details. Measure between them along the slope using consistent reference points.
Calculate the number of spaces
Divide the measured distance by your permitted maximum gauge and round up. One additional row accounts for the batten at each end of the spaced layout.
Convert rows into running length
Multiply rows by their length and the number of matching roof planes. Add your allowance, then divide by the supplier’s stock length to estimate full pieces.
Roof batten calculation formula
= round up(first-to-last distance ÷ maximum gauge)
Rows per plane
= spaces + 1
Calculated equal gauge
= first-to-last distance ÷ spaces
Net running length
= rows × row length × identical planes
Estimated stock pieces
= round up(length including allowance ÷ stock length)
Length and gauge are converted into compatible units before calculating. Existing matching full pieces are deducted after estimating the required stock quantity.
Example: two matching roof planes
Each plane has 10 m rows and a 5 m first-to-last distance. For an illustrative 300 mm maximum gauge:
Rows per plane = 17 + 1 = 18
Equal gauge = 5 ÷ 17 ≈ 294.12 mm
Net length = 18 × 10 × 2 = 360 m
With 10% allowance = 396 m
At 3 m per stock piece = 132 pieces
The 132-piece figure is a running-length estimate. Check cutting and joint positions before ordering. Also confirm that the calculated gauge is permitted for the chosen product and roof configuration.
Roof batten calculator questions
Why does the calculator add one to the number of spaces?
The measurement runs between the first and last batten positions. Seventeen spaces require eighteen rows because there is a batten at both ends. This convention must match the distance you enter.
Should I enter the full roof slope length?
Enter the distance between the specified first and last batten positions. Their offsets from the eave and ridge are not calculated here. The full roof slope length may therefore be different.
Does the calculated gauge confirm a compliant tile layout?
No. It produces equal spacing no greater than your entered maximum. You must also check the product’s minimum gauge, headlap, end details and other applicable requirements. The calculator does not validate those conditions.
Is the stock-piece quantity an exact cutting list?
No. It divides total length, including your allowance, by stock length. It does not allocate cuts, place joints over supports or determine which offcuts can be reused. Those constraints may increase the purchase quantity.
Can I use it for hips, valleys or unequal roof planes?
The model assumes identical rectangular planes with constant row length. Calculate unequal rectangular planes separately. Tapered rows near hips and valleys need a measured layout rather than this full-width-row estimate.
Are counter-battens or extra eave battens included?
No. Only the evenly spaced rows between your first and last positions are counted. Counter-battens, doubled rows, local reinforcement and other special details require separate quantities.
Does this choose the batten size, grade or fixing?
No. It calculates quantities from the supplied geometry. Batten section, grade, support conditions and fastening specifications must be established separately.
What does the optional material cost include?
It multiplies the estimated pieces to purchase by your price per full stock piece. It excludes fixings, labor, delivery and taxes. Currency selection labels your price without converting exchange rates.